The implementation of the wiring label identification system is to bring the greatest convenience to the future maintenance and management of users, improve its management level and work efficiency, and reduce network configuration time.

All facilities that need to be identified must have labels. Each cable, optical cable, wiring device, end contact, grounding device, and laying pipeline should be given a unique identifier. The identifier should be marked with the same number of letters and numbers, which are carried out in accordance with certain patterns and rules. It is recommended to choose the material according to the concept of "permanent logo", and the life of the label should be corresponding to the design life of the wiring system. The recommended label material complies with the guarantee of the permanent identification through UL969 (or corresponding standards); at the same time, it is recommended that the label to meet the environmental ROHS instruction requirements. All labels should be kept, complete, and meet the requirements of the environment. The label should be printed, and it is not allowed to fill in. It should be clearly visible and easy to read.

It is particularly emphasized that labels should be able to withstand the test of the environment, such as humidity, high temperature, and ultraviolet rays, and should have the same or longer service life as the identified facilities. Materials such as polyester, ethylene or polymyfin are usually the best choice. Establish documents for all management facilities. The document should be recorded and preserved by a computer. The simple and small wiring engineering can be managed according to paper documents such as drawing materials, and the record is accurate, timely updated, easy to check, and the document data should be Chinese.

1 outdoor and outdoor use

The labels for outdoor and outdoor use should be tested by the environment, such as humidity, high temperature, and ultraviolet rays, and should have the same or longer service life as the identified facilities. The recommended label material complies with the guarantee of the permanent identification through UL969 (or corresponding standards); at the same time, it is recommended that the label to meet the environmental ROHS instruction requirements.

2 cable logo

The most commonly used cable logo is covered with a protective film label. This label is sticky and has a layer of transparent protective film outside the printing section, which can protect the label printing font from wear. In addition, single -rooted cable/jumper can also use non -membrane labels, flag tags, and thermal casing tags. Common materials types include: ethylene, polyester, and polyfluoroethylene.

For bundling cables, it is recommended to use the identifier to identify. This sign can be printed by a printer. Nylon tie or felt bands are fixed with cables. It can be placed horizontally or vertically. The logo itself should have good tear -resistant performance and meet the standards corresponding to ROHS.

The most commonly used cable logo is covered with a protective film label. This label is sticky and has a layer of transparent protective film outside the printing section, which can protect the label printing font from wear. In addition, single -rooted cable/jump line can also use non -film labels, flag tags, and thermal casing tags, as shown in the figure.

3 Labels of Wiring Panel/Exit Panel

The wiring panel logo is mainly based on the flat logo, which requires the material to withstand the test of the environment, and meet the environmental requirements corresponding to the ROHS. It can still maintain good image quality in various solvents, and can be pasted to the low -surface energy plastic. Various surfaces. The label should be printed, and it is not allowed to fill in. It should be clearly visible and easy to read. All labels should be kept, complete, and meet the requirements of the environment.