This is a headache for many people. Here, Guangzhou Huipeng gives some pertinent suggestions.

1. The room where the network cables are arranged.

This first depends on the location of the weak current box in the house. What is a weak current box? It is the place where the TV coaxial cable, optical fiber, network cable, etc. enter the house. Now there is generally a power supply in the weak current box. Usually, it is recommended to place the light cat in the weak current box. The picture below shows the weak current box.

Secondly, it depends on the type of house. Although there are various suggestions, Takefu suggested that the wireless router should be placed in the middle of the house, so that the average house of about 130 square meters is basically no problem. The current router style is also relatively fashionable. The router in my home is directly placed on the TV cabinet in the living room. The picture below shows a router of a certain brand.

Second, the choice of wire.

There are many types and brands of network cables, here Wu Fu has two suggestions:

First, the strong electricity and weak points can be kept as far away as possible;

Second, try to choose Category 6 shielded cable for the network cable (please contact 020-87551666 to purchase Category 6 shielded cable).

Because there is a lot of room for changes during decoration, it is not worth changing after painting the wall. So don't save hundreds of dollars when wiring, buy a shielded, Gigabit network cable Category 6 cable. The following figure shows the line type:

Third, the choice of the router.

First of all, make it clear that you don't need to replace a home router if you buy one. Like your mobile phone, it will become outdated, so the current recommendation is based on the current situation.

First, you must buy a gigabit router. The wireless protocol should be 802.11ac, and the Wan and Lan ports of the router should also be gigabit. Because the speed of home broadband network is increasing rapidly, now 100M is popular, 200M has also been launched, don't wait for a 200M broadband from the operator, use a 100M router, receive 802.11b wifi , then don't blame the operator, your fastest speed is 40M.

Second, try to use one router for networking. It is impossible for everyone to have a network engineer. If a problem can be solved with a router, try to solve it with a router. In the future, if there is a problem, you can just change the router. Similarly, don't be superstitious about using various signal amplifiers, wireless APs, etc., and you don't know where to start when something goes wrong.

The third is to not use some insignificant functions. The most important thing about a router is stability. It can run normally for a few years without any problems. If there is no special need for some insignificant programming, downloading, and sharing functions, try not to.

4. Remedial measures.

In fact, it's just some back tricks, and it also makes many people feel at ease.

Not every room has to use two network cables.

In fact, when the short-distance transmission rate is below 100M, you only need to use 4 wires in the network cable. According to the order of "orange white orange, green white blue, blue white green, brown white brown", the normal use is 1, 2, 3, 6, and the other 4 are not used. So you don't have to worry about a certain line being broken (most of this happens because of the network cable connector), and you can even use one as two. And this is what most maintenance guys don't tell you.